Planet UPOE-800G - Page 10

10
4.RecoveringBacktoDefaultConguration
 IP Address has been changed or admin password has been forgotten –
To reset the IP address to the default IP address “192.168.0.100” and the user
password to factory default mode (default password is sw + the last 6 characters of
the MAC ID in lowercase), press the hardware-based reset button on the front panel
for about 10 seconds. After the device is rebooted, you can log in the management
Web interface within the same subnet of 192.168.0.xxx.
8-Port Gigabit 802.3bt PoE
++
Managed Injector Hub
UPOE-800G
Reset
SYS PWR
PoE Fail
FAN1 FAN2
1 3 5 72 4 6 8
bt PoE-in-Use
at/af PoE-in-Use
Fail
PoE-in-Use
BT
95W
AT
30W
Management
LNK/ACT
Reset
Figure 4-1: 802.3bt PoE++ Managed Injector Hub Reset Button