1. Package Contents
Note
– 1 – – 2 –
– 3 – – 4 –
– 7 – – 8 –
– 5 – – 6 –
Front Panel of VDR-300NU
Button and Ports of VDR-300NU
VDSL2 Router
Quick Guide
CD-ROM
RJ-11 Cable
VDSL Splitter
The above steps introduce simple installations and configurations
for the VDR-300NU. For further configurations of different opera-
tion modes, please refer to the user’s manual in the CD. If you
have further questions, please contact the local dealer or distribu-
tor where you purchased this product.
2011-AC0360-000
Thank you for choosing PLANET VDR-300NU. Before installing the
AP, please verify the contents inside the package box.
If there is any item missing or damaged, please
contact the seller immediately.
STEP 1: Connect the Power Adapter to VDR-300NU. Check
whether the PWR LED and LAN LED on the front panel
are on accordingly.
STEP 2: Follow the figure below to connect the network
devices.
VDR-300NU
Quick Installation Guide
802.11n Dual Band Wireless VDSL2 Router
STEPS: Set your computer to get an IP address from the
Wireless Router:
1. Click “Start” button located at lower-left corner of the
screen.
2. Click “Control Panel”.
3. Double-click “Network and Sharing Center” icon.
4. Click “Change Adapter Settings”.
5. Double-click “Local Area Connection” icon.
6. Select “Internet Protocol Version 4 (TCP/IPv4)” and
click “Properties” button.
7. Select “Obtain an IP address automatically” and
“Obtain DNS server address automatically”, and then
click the “OK” button twice to save the configuration.
VDSL2 Router with PPPoE:
Follow the steps below to set up connection to PPPoE mode.
1. Log in the VDR-300NU’s web-based configuration utility.
2. Click “WAN Service”.
3. Click “Add” icon.
4. Choose PTM, and then press “Next”.
5. Select the WAN service type: “PPPoE” and click the
“Next” button.
6. Fill in User Name and Password which are provided by ISP.
7. After setting it up, press “Apply/Save”.
If you need more information about WAN service, please refer
to the User’s Manual.
VDSL2 Router with Bridge:
Follow the steps below to set up connection to Bridge mode.
1. Log in the VDR-300NU’s web-based configuration utility.
2. Click “WAN Service”.
3. Click “Add” icon.
4. Choose PTM, and then press “Next”.
5. Select the WAN service type: “Bridging” and click the
“Next” button.
6. Press “Apply/Save”.
If you need more information about WAN service, please refer
to the User’s Manual.
Power Adapter
RJ-45 Cable
DSL
LAN4 LAN3 LAN2 LAN1
Reset
USB2
Power
Power Adapter
Power
DSL
LAN4 LAN3 LAN2 LAN1
Reset
USB2
Power
RJ-11
RJ-45
PC/Laptop
Phone Jack
Splitter
Power Adapter
Power
Telephone
LINE
PHONE
MODEM
Default IP Address: 192.168.1.1
Default User Name: admin
Default Password: admin
Default SSID: VDR-300NU
Default Wireless Security: Open
Now, you can see the Web management UI of the VDR-300NU.
2. Physical Introduction 4. Web Login
5. Broadband Connection for VDSL Further Information
3. Hardware Installation
Power DSL USB1WLAN USB2Internet
LAN 1~4
WPS
PowerDSL USB2
USB1
Power
Reset
LAN 1~4
To Next Page
Need help?
General
