17
PHONEBOOK
STEPS TO ENTER NAMES AND SPECIAL
CHARACTERS USING THE KEYPAD
Refer to the letters on the number keys to select the desired
characters. With each press of a number key (0– 9), the
displayed character appears in the following order: Upper case
letters first, lower case letters next and finally the number
corresponding to the key.
When entering names and/or phone
numbers, each of the four steps in the entry
process must be completed. A “Done”
message and a beep indicate the
name/phone number is complete.
When the phone is in the standby mode
(Talk button not pressed), press /tSPEED.
The remote displays the number of the
Phonebook locations used, and information
on searching and storing Phonebook
locations.
(1ST LINE) The
number of the
Phonebook entries
(2ND LINE) Press the number keypad,
▲ or ▼ to search
(3RD LINE) Press SELECT/CH button to
begin the storage process.
USING THE PHONEBOOK
IF YOU MAKE A MISTAKE WHILE ENTERING A NAME
Use /
t SPEED or CIDs to move the cursor to the incorrect
character. Press DELETE to erase the wrong character, then enter the
correct character. To delete all characters, press and hold DELETE.
16
To Next Page
Loading...
