12
• Hydraulic connection of the toilet
In correspondence of the suspended toilet holder (1) connect to the waste
line (2) the hose fitting Ģ 40mm provided (4), tightening it with the collar
(clamp) 32-50 provided (5).
For the "All-in-One" versions, connect to the waste water collection pipe of
the additional utilities(3) the second hose connection hose ø 40mm provi-
ded (7), tightening it with the collar (clamp) 32-50 provided (6).
Insert in the cavity the water inlet pipe of the toilet equipped with a filter (1).
Fasten the hose holder of the toilet drain (2) to its hose connection (3) via
the collar (clamp) 32-50 provided (4).
In the case of the "All-in-One" version, attach the respective hose holder (5)
to its
Flexible fitting (6) via collar (clamp) 32-50 supplied (7).
In case of "KB" version, insert the hot (8) and cold (9) water hoses of the in-
tegrated bidet mixer into the cavity.
To Next Page
Loading...