9INSTRUCTION MANUAL
1. To set your PRO501VXP to the parts counting
mode, once the scale has been turned on and it
has stabilized, place the desired quantity of items
you wish to count onto the weighing platform (25,
50, 75 or 100 pcs).
2. Press and hold the PCS button for 2 to 3 seconds.
The screen will begin to flash a quantity (25, 50,
75 or 100). To select a specific quantity, press the
MODE button and continue to press the button
repeatedly while scrolling through the various units
of measure until the display reads your desired
parts quantity.
3. Press the PCS button once more as soon as
the desired quantity is found. The display will
then read “pcs” in the upper left hand corner of
the display to indicate that the PCS function is
enabled.
4. You may switch between your PCS mode and
regular weighing by pressing the “MODE” button.
Your scale will continue to retain the last “PCS”
setting made until you go through the above
process again.
5. In many cases (when counting very small or round
parts, etc.) it is more practical to use a weighing
tray (scoop or container) to hold the parts you
To Next Page
Loading...