EasyManua.ls Logo

pleasant hearth VFS2-NT20DT - User Manual

pleasant hearth VFS2-NT20DT
62 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
VENT-FREE GAS
DUAL FUEL HEATER
MODEL #
VFS2-PH20DT/VFS2-L20DT/VFS2-NT20DT
VFS2-PH30DT/VFS2-L30DT/VFS2-NT30DT
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
CAUTION - FOR YOUR SAFETY
WARNING:
This appliance is
equipped for (Natural
and Propane) gas.
Field conversion is
not permitted other
than between natural
or propane gases.
- Do not store or use gasoline or other ammable vapors and Iiquids in vicinity of this
or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the re department.
- Installation and service must be performed by a qualied installer, service agency or
the gas supplier.
This is an unvented gas-red heater. It uses air (oxygen) from the room in which it is
installed. Provisions for adequate combustion and ventilation air must be provided.
Refer to Air For Combustion and Ventilation section on page 8-10 of this manual.
This appliance may be installed in an aftermarket, permanently located manufactured
(mobile) home, where not prohibited by local codes. This appliance is only for use with
propane or natural gas. This appliance is equipped with a simple means to switch between
propane and natural gas. Field conversion by any other means including the use of a kit is
not permitted.
Dual Fuel
Patent Pending Dual
Fuel Technology
ANS Z21.11.2-2016
IMVFSG2L - 2019-2-27
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-447-4768, 8:30 a.m. – 4:30 p.m., CST, Monday – Friday or
email us at customerservice@ghpgroupinc.com.
US
NG LP

Table of Contents

Questions and Answers

  • K
    kevinhoweSep 10, 2025
    How to fix no spark at ODS/pilot when pressing ignitor button on pleasant hearth Gas Heater?
    • L
      Lauren GomezSep 10, 2025
      If the ignitor button is pressed in, but there is no spark at ODS/pilot on your pleasant hearth Gas Heater, the ignitor electrode may be positioned wrong or broken, in which case you should replace the electrode. The ignitor electrode might not be connected to the ignitor cable, or the ignitor cable could be pinched, wet, or damaged; replace the ignitor cable, free it if pinched, and keep it dry. A bad push button ignitor or a bad battery could also be the cause; replace the push button ignitor or check and replace the battery if needed.
  • L
    Leslie MartinSep 12, 2025
    What to do if there's a spark but no ignition on my pleasant hearth Gas Heater?
    • L
      leesmithSep 12, 2025
      If the ignitor button is pressed in, and there is a spark at the ODS/pilot but no ignition on your pleasant hearth Gas Heater, ensure the gas supply is turned on and the equipment shutoff valve is open. Make sure the control knob is fully pressed in while pressing the ignitor button and that the control knob is in the PILOT position. If there is air in the gas lines, continue holding down the control knob and repeat the igniting operation until the air is removed. A clogged ODS/pilot could also be the issue; clean or replace the ODS/pilot assembly. If the gas regulator setting is incorrect, replace the gas regulator. Finally, if you have a propane model, the gas supply may be depleted; contact your local propane/LP gas company.
  • C
    Cynthia AtkinsonSep 14, 2025
    Why is the burner backfiring during combustion in my pleasant hearth Gas Heater?
    • C
      Caroline JacksonSep 14, 2025
      If the burner is backfiring during combustion in your pleasant hearth Gas Heater, the burner orifice may be clogged or damaged; clean the burner orifice. The burner could also be damaged. Additionally, the gas regulator might be damaged, so replace the gas regulator.
  • R
    Robert ObrienSep 16, 2025
    Why is there slight smoke or odor during initial operation of my pleasant hearth Gas Heater?
    • J
      jenniferjohnsonSep 16, 2025
      If you notice a slight smoke or odor during the initial operation of your pleasant hearth Gas Heater, it is likely due to residues from the manufacturing process. This problem should stop after a few hours of operation.

pleasant hearth VFS2-NT20DT Specifications

General IconGeneral
ModelVFS2-NT20DT
Heating Capacity20, 000 BTU
Fuel TypeNatural Gas
ColorBlack
Ignition SystemPiezo Ignition
Vent TypeVent-free
Heating AreaUp to 700 sq ft
Efficiency99.9%
TypeVent-Free Gas Heater
Safety FeaturesOxygen Depletion Sensor (ODS)

Related product manuals