4
le. If you want to make each song a separate le, press the forward button inbetween
songs to start recording a new le.The LED will indicate this by turning off for 2 seconds
and then resume blinking.
Automatic mode
Automatic mode is activated by holding in the forward button for 3 to 5 seconds when no
tape is playing, the LED will indicate this by turning blue. When auto mode is activated
the player will detect the interval between songs and make each song a separate le.
If there is a long pause in a song the player might detect this as a new song and make a
new le. If the interval between two songs is too short the player might detect them as
one song and keep them together as one le.
If any of the two situations above occur you can use the free software Audacity to
edit the les to your liking. Download the software from the following link: http://www.
audacityteam.org/download/.
Other sources
The player can also record other sources of sound via the AUX connection with a cable,
as long as the device has an audio line out function.
Playback
If you want to listen to recorded les on the player press the play/pause button on the
front. The LED will start slowly ashing to indicate playback mode. Use the rewind/
forward buttons to navigate between les. Adjust the volume by pressing the +/-
buttons. The player can also play other MP3s if these are placed in the TAPEMP3 folder
on the Micro SD card.
Safety information
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Depleted batteries should be removed and replaced by a similiar kind. Dispose batteries
according to local regulations.
ENGLISH
To Next Page
Loading...