5
Proceed as follows to activate an RS-485/ETH interface:
Example: An inverter bus with 10 x SMA inverters was connected to the RS-485-A port:
Press the "inactive" button under RS485-A. Now select "Inverter" and confirm. Under
RS485-A, select the manufacturer "SMA" and confirm.
Repeat this procedure for RS485-B and/or RS485-C (for PL500+) if required.
The RS485/ETH interface stress has been defined. Continue with "next".
Step 2
Depending on the model, additional ETH interfaces are available for additional devices.
Figure 5:
To Next Page
Loading...