Service &
Maintenance
10.6 Six Monthly Inspections Access™ EA & Access™ EAB
Six Monthly Inspection Check List
Lift no:
Vehicle Reg:
Engineer’s Name: Date:
Customer Details:
Address, Contact:
Tel Number: OK
1 Check all fixing bolts and brackets connecting lift onto vehicle chassis.
2
Remove pump box cover and check hydraulics / electrics for wear or
damage.
3
Check lifting cylinders for leaks, change seals if necessary. Adjust/
tighten hoses if required (35 N/m of torque for hydraulic fittings).
4
Remove outside ‘arm side guard’ cover. Check bridge plate gas strut
operation. Check all linkages, fittings and wheels for wear. Tighten and
5 Check all visible hoses and fittings for leaks or damage.
6 Check handrail fittings are tight.
7 Check condition/security of arm side guards.
8 Check all fittings are tight particularly the arm pins.
9 Check bridge plate and platform hinges for correct operation.
10
Check roll-off ramp assemblies for correct operation. Pay particular
attention to spring position and operation.
11 Check vertical stow rubber for wear (located in rear corners of platform).
12 Check condition of SWL sticker and other lift decals.
13
Coat all electrical connections with petroleum jelly or proprietary electrical
grease.
14
Check hand pump operation, lubricate all pivot points. REMEMBER TO
RETURN MANUAL-TAP(S) TO THEIR ORIGINAL POSITION.
15 Perform weight test in accordance with current Loler standards.
16 Ensure that grease points are re-greased/ lubricated.
10.6 Six Monthly Inspections Access™ EA & Access™ EAB
For Factory Trained Lift Engineers
As monthly safety checks plus:
IF IN DOUBT, CONTACT THE MANUFACTURER
10
To Next Page
Loading...
Need help?
General