1) This equipment needs to be installed and put into service in accordance with the
information provided in the ACCOMPANYING DOCUMENTS;
This product needs special precautions regarding EMC and needs to be installed and
put into service according to the EMC information provided, and this unit can be
affected by portable and mobile RF communications equipment.
2)* Caution: Do not use a mobile phone or other devices that emit electromagnetic
�ields, near the unit. This may result in incorrect operation of the unit.
3) *Caution: This unit has been thoroughly tested and inspected to assure proper
performance and operation!
4) * Caution: this machine should not be used adjacent to or stacked with other
equipment and that if adjacent or stacked use is necessary, this machine should be
observed to verify normal operation in the con�iguration in which it will be used.
Guidance and manufacture’s declaration – electromagnetic emission
Emission test Compliance Electromagnetic environment – guidance
The Non Contact Infrared Body Thermometer is intended for use in the electromagnetic environment
speci�ied below. The customer of the user of the Non Contact Infrared Body Thermometer should assure that
it is used in such an environment.
The Non Contact Infrared Body Thermometer use RF energy
only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in
nearby electronic equipment.
The Non Contact Infrared Body Thermometer is suitable for
use in all establishments, other than domestic and those
directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
RF emissions
CISPR 11
RF emission CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage �luctuations/
�licker emissions
IEC 61000-3-3
Group 1
Class B
Not applicable
Not applicable
8-EMC Declaration
37
To Next Page
Loading...