0.00.45
INTRODUCTION
ForSimulatorUseOnly DONOTDUPLICATE 01OCT08
PMDG MD-11
2D Cockpit:
Display and Manipulation of 2D Panel Sections:
In previous PMDG products, we have used a designated panel
switching device that was displayed embedded in the 2D panel, or
floating above the panel.
For the PMDG MD-11, we have implemented a new, less visually
distracting method to allow the user control of 2D panel sections. This
new panel control method allows the user much finer control of 2D
panel view options, and will quickly become an intuitive and easy to use
visual interface.
The essence of the PMDG MD-11 2D Panel Control schema is based
around click spots located at strategic locations throughout the 2D
panel-set. When the user moves the mouse over one of these click
spots, the mouse cursor changes in order to help the user understand
what options are available via the click-spot.
The following cursors may be displayed to the user:
Panel Open/Toggle Cursor:
When this cursor is displayed, you can use the left mouse button to
open or toggle a panel window. These types of mouse click spots are
normally located on the main panel.
Multiple Panel Open/Toggle Cursor:
When this cursor is displayed, you can use either the left or the right
mouse button to open or toggle one of two different panel windows. A
left mouse click is related to one panel window, the right mouse click is
related to another different panel window. These mouse click spots are
usually located on the main panel.
To Next Page
Loading...