PMS HT329M1 - Getting Started and Accessories; Preparation for Use; Standard Accessory Kits

PREPARATION FOR USE
1. Insert 3V battery, making sure it is positioned correctly.
Connect to the pad and place on the skin area.
2. Touch the right button to turn on unit and raise density level
or touch the left button to lower the density level and turn off
the unit.
3. Turn on the unit. The LCD screen display will show P1 (touch
mode button to change program to P2...PO, there are ten
programs).
4. When the program has been changed, the density level w ill
return to "0". To raise the density, simply press the right
button again.
5. Touching the right or left button will activate the density
function and the LCD display the density level. After 10
seconds the LCD w i l l display the number of minutes that the
unit is on for, the density and the mode every 3 seconds.
6. The unit works for a period of 30 minutes and then will
automatically turn off.
7. If the density level remains at 0 for more than 3 minutes,the
unit will automatically switch off.
8. The mode button will fast forward when pressed, the density
button will not.
5 STANDARD A C C E S S O R I E S
The Electric Stimulator Kit have 3 different Contents:
1.) Electrode contains :
a. Electrical S t i mu l at o r X 1
b. Dual poles Self Adhering Pad X1
d. Operating Manual X 1
e. 3V(CR2025) Battery X 1
g. Packing Plastic Case x 1
2.) Slim belt set contains :
a. Electrical Stimulator X 1
b. Conductive slim belt X 1
c. Conductive gel X1
d. Elastic Strap L X1
e. Elastic Strap S X 1
f. Operating Manual X 1
g. 3V(CR2025) Battery X 1
h. Packing Plastic Case X1
3.) Electrode & Slim belt set contains :
a. Electrical Stimulator X 1
b. Conductive slim belt X 1
c. Conductive gel X 1
d. Elastic Strap L X1
e. Elastic StrapS X1
f. Dual poles Self Adhering Pad X 1
g. Operating Manual X 1
h.3V(CR2025) Battery X1
I. Packing Plastic Case X1