14 - User manual
7. Master code reset
Register card for adding cards
Register card for deleting cards
• Turn o the power.
• Press and hold the access button while restarting the power.
Alternative procedure if you do not have an access button
installed: connect the blue and yellow wires.
• You will hear a double beep. The indicator LED turns light
green.
• Read the first card that will be registered as a master card to
add other cards.
• You will hear a beep. The LED turns green and soon turns light
green.
• Read the second card that will be registered as a master card
for deleting other cards.
• You will hear a beep. The LED turns green and soon turns red.
After the reset, the Master code returns to 999999.
Through this reset procedure, user data will not be deleted. To
delete all users, run the command * Master code # 2 0000 #
Master card operations
Add card
Read the master card, then Read the first user card, then Read
the second user card (and so on), then Read the master card
again.
Note: With the master card you can add user cards continuously
To Next Page
Loading...
