18
13. Installed equipments
For the use of equipment installed on-board (VHF, pilot, central navigation console…), please refer to
their specific manuals enclosed with the boat.
In case of problem with one of these equipment’s, please contact the reseller of the particular brand.
Setting and initialization of the equipment :
Certain equipment such as the automatic pilot or the speed sensor requires an initialization before
use. Therefore, it is important to refer to the manual for these devices to do the setup in an optimum
way.
Valves and plumbing :
All the valves must be closed after use.
List of installed seacocks on board:
Speed sensor: situated in the heads bathroom furniture. The instruments are replaceable
and should be able to be removed.
Kitchen: The evacuation of the sink is done by a valve, situated under the kitchen furniture.
You can access to the valve by opening a trap under the cooking device
WC: It requires two valves for its functioning. The water inlet and the discharge valve. They
are both situated in the bathroom furniture in the heads. (See previous page)
Exhaust: Engine exhaust is evacuated above the waterline, behind the aft watertight
bulkhead. The through hull fitting is accessible by the starboard locker
It is important that adapted wooden plugs always are available to block the seacocks in case of a
waterway.
Regularly check the connections of the flexible piping system aboard, on the valves as well as the
state of the hose clamps.
Electrical circuit :
It is recommended to entirely cut the electrical circuits for all batteries after each navigation (after
having turned off all the electrical devices aboard). The circuit breakers are situated on the starboard
side of the engine compartment.
To Next Page
Loading...
