POGS The Gecko - For Your Safety; Important Safety Instructions; Protect Your Hearing

Updated February 21, 2022
10
Problem
Possible cause
Solution
POGS Bluetooth®
doesn’t switch on.
The battery is empty.
Charge the battery or connect
your POGS to your device of
choice with the QuickSafe
cable.
No audio playback via
POGS headphones.
The Bluetooth®
function of your POGS
is switched off.
Switch the Bluetooth®
function on. (See section on
activating Bluetooth®).
POGS and your media
device are not or no
longer paired (LED
light should be flashing
every 7 seconds when
paired).
Check all settings as
described in the section for
Bluetooth® pairing.
The Bluetooth®
function is switched
off on the device.
Switch the Bluetooth®
function on. If applicable,
refer to the instruction
manual for the device.
No audio playback
despite Bluetooth®
connection.
Volume has been set
too low.
Increase the volume on your
external device.
For your safety
Important safety instructions
1. Read and keep these instructions.
2. Follow all instructions and warnings.
3. Clean only with a dry cloth.
4. Do not wear the headphones while charging.
5. Use only attachments/accessories specified by POGS.
6. Refer all servicing or repairs to POGS (www.pogsheadphones.com).
7. Do not expose your headphones to rain, dripping, splashing or moisture of any
kind. For instance, do not use your headphones outdoors during a thunderstorm,
as this may result in electric shock or malfunction of your headphones.
8. To reduce the risk of electric shock, these headphones are intended to be used
only with the charging cable provided by POGS.
Protect your hearing