point POAC8014 - Handling the Remote Controller; Inserting and Replacing Batteries

The air conditioning may come with two
batteries(some units). Put the batteries in
the remote control before use.
1. Slide the back cover from the remote
control downward, exposing the battery
compartment.
2. Insert the batteries, paying attention to
match up the (+) and (-) ends of the
batteries with the symbols inside the
battery compartment.
3. Slide the battery cover back into place.
SPECIAL NOTE
• If the indoor unit does not have a particular function, pressing that function’s
“USER’S MANUAL” on function description, the description of “USER’S
MANUAL” shall prevail.
Handling the Remote Controller
Inserting and Replacing Batteries
BATTERY NOTES
For optimum product performance:
• Do not leave batteries in the remote control if you don’t plan on using the
device for more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted municipal waste. Refer to local laws
for proper disposal of batteries
TIPS FOR USING REMOTE CONTROL
• The remote control must be used within 8 meters of the appliance.
• The appliance will beep when remote signal is received.
• Curtains, other materials and direct sunlight can interfere with the
infrared signal receiver.
• Remove batteries if the remote will not be used more than 2 months.
5
GB
GB