29
Removing the collected water
There are three ways to remove collected water.
1. Use the bucket
z
When the appliance is off, if the bucket is full, the Full indicator light will
light.
z
When the appliance is on, if the bucket is full, the compressor and the fan
turn off, and the Full indicator light will light, the digital display shows P2.
z
Slowly pull out the bucket. Grip the left and right handles securely, and
carefully pull out straight so water does not spill. Do not put the bucket
on the floor because the bottom of the bucket is uneven. Otherwise the
bucket will fall and cause the water to spill.
z
Throw away the water and replace the bucket. The bucket must be in right
place and securely seated for the dehumidifier to operate.
z
The appliance will re-start when the bucket is restored in its correct
position.
1.
Pull out the bucket a little.
2.
Hold both sides of the bucket with
even strength, and pull it out from the
appliance.
3.
Pour the water out.
Pump hose drops Reinstall pump hose properly
To Next Page
Loading...