25
covered.
z
Switch the appliance off and remove the plug from the mains, or
switch off or turn out the circuit breaker of fuse.
z
Clean the appliance and the interior accessories with a cloth and
lukewarm water. After cleaning wipe with fresh water and rub dry.
z
After everything is dry place appliance back into service.
Troubleshooting
Caution!
Before troubleshooting, disconnect the power supply. Only
a qualified electrician of competent person must do the
troubleshooting that is not in this manual.
Important!
-
There are some sounds during normal use (compressor, refrigerant
circulation).
Problem Possible cause Solution
Appliance does not
work
Mains plug is not plugged in or is
loose
Insert mains plug.
Fuse has blown or is defective Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
Appliance freezes or
cools too much
Temperature is set too cold or the
appliance runs at SUPER modes.
Turn the temperature regulator
to a warmer setting temporarily.
The food is not frozen
enough.
Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature to a colder
setting temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Heavy build up of frost
on the door seal.
Door seal is not air tight.
Carefully warm the leaking
sections of the door seal with a
hair dryer (on a cool setting). At
the same time shape the warmed
door seal by hand so that it sits
correctly.
To Next Page
Loading...
