Polar Refrigeration T316

Questions and Answers

K
Kara PottsAug 13, 2025
How to fix a Polar Refrigeration T316 that is not working?
- V
  Veronica SullivanAug 13, 2025
  If your Polar Refrigeration Ice Maker is not working, first ensure it is correctly plugged in and switched on. Check the power supply. If the plug fuse has blown, replace it. If the ambient temperature is below 10°C, move the appliance to a warmer location. Also, verify that the water supply is on and the supply hoses are not blocked. For damaged plugs/leads or internal wiring faults, contact a POLAR agent or qualified technician.
D
Daniel JonesAug 21, 2025
What to do if the Ice Full indicator is lit on my Polar Refrigeration T316 Ice Maker?
- T
  tammybernardAug 21, 2025
  If the 'Ice Full' indicator is illuminated on your Polar Refrigeration Ice Maker, it could be due to two reasons. First, the ice bin might be full, in which case you should empty it. Second, the room temperature may be too low, so you should move the appliance to a warmer location.
L
Laura FernandezAug 25, 2025
How to troubleshoot a Polar Refrigeration Ice Maker that is not working?
- M
  Marc SotoAug 25, 2025
  If the Polar Refrigeration Ice Maker is not working, make sure that the appliance is correctly plugged in and switched on. If the plug fuse has blown, replace it. Ensure the power supply is working. Also, check that the water supply is on and the hoses are not blocked. If the ambient temperature is below 10°C, move the appliance to a warmer location. For damaged plugs or internal wiring faults, contact a POLAR agent or qualified technician.
E
Emily PetersAug 28, 2025
What to do if the Water indicator is lit on my Polar Refrigeration Ice Maker?
- C
  Connie PageAug 28, 2025
  If the 'Water' indicator is lit on your Polar Refrigeration Ice Maker, first, check if the ice maker is connected to the water supply and connect it if it is not. Second, the water filter may be blocked, so you should clean it and restart the ice maker. Also, the water pressure may be too low. The water pressure should be between 101,352.97 Pa - 806,686.92 Pa (14.7-117psi). Call a plumber to check the water supply.
T
tammyconnerAug 31, 2025
What does it mean when the Fault indicator is lit on my Polar Refrigeration T316 Ice Maker?
- S
  Samantha AdamsAug 31, 2025
  If the 'Fault' indicator is lit on your Polar Refrigeration Ice Maker, first remove any ice blockage from the water tray to ensure it is in the proper position. Then check that the ice sensor is not obstructed. If it is not blocked and the fault persists, or if the water tray does not tilt and the motor is not working, contact a POLAR agent or a qualified technician. Also check that water tank is not blocked.
A
Adrienne HenrySep 5, 2025
What to do if Water and Ice Full indicators flash together on Polar Refrigeration T316 Ice Maker?
- P
  Paige JohnsonSep 5, 2025
  If the Water and Ice Full indicators are flashing together on your Polar Refrigeration Ice Maker, it indicates that the water box is blocked and cannot tilt. To resolve this, disconnect the ice maker from the power supply, remove some of the ice cubes, and gently tilt the water box by hand. After doing this, restart the ice maker after 3 minutes.
T
Tony MarquezSep 8, 2025
Why does the compressor run, but no ice is made in my Polar Refrigeration Ice Maker?
- D
  David DiazSep 8, 2025
  If the compressor runs but no ice is being made in your Polar Refrigeration Ice Maker, it could be due to a refrigerant leak or a blockage in the refrigerant system. In this case, you should call a POLAR agent or a qualified technician.
S
Sandra LittleNov 16, 2025
Why is my Polar Refrigeration T316 Ice Maker noisy or working intermittently?
- S
  Shannon WhiteNov 16, 2025
  If your Polar Refrigeration Ice Maker is noisy or works intermittently, try the following: * If there are power fluctuations, turn off the ice maker and restart it after 3 minutes. * If the water is not connected, connect the ice maker to the water supply. * If the water filter is blocked, clean it and restart the ice maker. * If the ice bin is full, empty it. * If the room temperature is too low, move the appliance to a warmer position. * If the water box is blocked, disconnect the power, remove some ice cubes, gently tilt the water box by hand, and restart the ice maker after 3 minutes. * If the water tray is not in the proper position, remove any ice blockage. For low water pressure (it should be between 101,352.97 Pa - 806,686.92 Pa (14.7-117 psi)), call a plumber to c...