A--39
MAINTENANCE
Brake Adjustment
Ifexcessive brake lever to brake block clearance is evident, the brake cable or cali-
per should be adjusted using the following methods.
Cable Adjustment
1. Make sure floating parts
move freely and all parts are
mounted securely. Tighten
hardware as required.
2. Check actuator linkage to
ensure there is adequate
freedom of movement for
positive brake operation.
3. Brake lever freeplay should
be 1/4″-3/8″ (6-10mm).
WARNING
Improper brake adjustment could result in brake failure which could result in
severe injury or death.
Brake Band
1/8-3/8″ (3-10 mm)
Brake
Cable
Pin/Set Screw
To Next Page
Loading...
