39
FEATURES
Multi-Function Instrument (MFI)
COMPASS: The compass displays true vehicle heading relative to
magnetic north with a resolution of 16 points per revolution. The
triangular pointer rotates to indicate the direction of travel.
VOLTMETER: The left side of the m ulti-purpose display contains
the battery VOLTMETER. Battery voltage is displayed from 5 to 18
volts in .1 volt increments. A battery voltage of less than 10. 9 volts
will trigger the “LOW POWER” warning message, indicating battery
voltage is approaching a “no start” condition.
DISTANCE METER: The center of the MFI contains a resettable
DISTANCE METER. Distance is displayed form 0 to 999.9 miles
(0-999.9 km) in .1 increments. To reset the DISTANCE METER,
simply press and hold the DISTANCE RES ET button until the distance
displayed returns to “000.0”.
HOUR METER: The right side of the multi-purpose display contains
the engine HOUR METER. Actual engine operating hours are
displayed in .1 hour increments from 0 to 999.9 hours. The HOUR
METER cannot be reset, and is retained even when power i s removed
due to nonvolatile EEPROM memory.
SPEEDOMETER: The right side of the MFI contains an analog
speedometer. While the speedometer is traditional in appearance, it is
actually controlled by the system microprocessor, and is extremely
accurate.
SECURITY LOCK: Briefly pressing and releasing the LOCK button
will cause the lock status to be displayed,either “LOCKED” or
“UNLOCKED”. Pressing and holding the LOC K button for several
seconds initiates the SECURITY LOCK function. The MFI will
display“ENTERCODE____”.Enterthecodeusingthe5-button
keypad. The factory set default code is “1234”. An asterisk (*) will
appear with each press of a numeric button. If the proper code has been
entered, the display will show the new lock status. If previously
“LOCKED”, the security lock will switch to “UNLOCKED” and the
vehicle may be started normally. If previously “UNLOCKED”, the
security lock will switch t o “LOCKED” and the vehicle will not start.
If starting the engine is attempted while the security lock is set to
“LOCKED”, the warning LED will flash, the engine will not start, and
the MFI will indicate “LOCKED”, followed by “ENTER CODE_ _ _
_”. If an improper code entered, the MFI will display “INVALID
CODE”, and exit code entry mode.
To Next Page
Loading...
Need help?
General
