51
OPERATION
Pre-Operation Inspection
Hull
Inspect the hull for cracks or damage. Do not operate the watercraft if
the hull is damaged.
Use a non-abrasive cleaner to remove any marine growth.
Drain Plug s and Bilge
Turn the bilge drain plug (1) counterclockwise
and remove it. Clean the plug and plug hole
of any sand and debris before reinstalling.
NOTE: Some models have more than one
drain plug.
When the watercraft is out of the water, remove the
drain plug and carefully flush out the bilge with fresh
water. Allow the bilge t o drain completely. Wipe out the
bilge with dry shop towels and reinstall the drain plug. After launching
the craft, remove the seat and check for leaks.
Riding Gear
Be sure all operators and passengers have the appropriate riding gear,
including a PFD. See page 16. Make sure all trailing objects are
securely tied back or stowed.
1
Objects trailing from a person in the water or from the watercraft
can easily become tangled in the jet pump impeller and cause
severe injury or death. Make sure long hair, straps, ropes, clothing
and similar objects are tied back and secured.
WARNING
To Next Page
Loading...
Need help?
General
