47
OPERATION
Pre-Operation Inspection
Hull
Use a non-abrasive cleaner to remove any marine
growth and inspect the hull for cracks or damage. Do
not operate the watercraft if the hull is damaged.
Drain Plugs and Bilge
Turn each bilge drain plug (1)
counterclockwise and remove
it. Clean the plug and plug
hole of any sand and debris
before reinstalling. Do not
operate the watercraft if any
drain plug is loose or
missing.
When the watercraft is out of the
water, remove the drain plugs and carefully flush out
the bilge with fresh water. Allow the bilge to drain
completely. Wipe out the bilge with dry shop towels
and reinstall the drain plugs. After launching the craft,
remove the seat and check for leaks.
Riding Gear
Be sure all operators and passengers have the
appropriate riding gear, including a PFD (see page 16).
Make sure all trailing objects are securely tied back or
stowed.
1
WARNING
Objects trailing from a person in the water or
from the watercraft can easily become entangled
in the jet pump impeller and cause severe injury
or death. Make sure long hair, straps, ropes,
clothing and similar objects are tied back and
secured.
To Next Page
Loading...
Need help?
General