62
OPERATION
Stopping the Watercraft
The operator of the watercraft should practice stopping
to become familiar with the procedure. Stopping is
affected by gross weight (watercraft and rider), vehicle
speed, wind direction and water surface conditions.
The watercraft is not equipped with a brake system.
When the throttle is released, the natural drag of the
water slows and stops the watercraft.
Always keep a safe distance from other vessels,
swimmers, objects in the water and the shoreline.
Refer to local regulations about safe operating
distances for the body of water you operate on.
Allow yourself plenty of room for stopping. When
operating at full speed (1), it could take the watercraft
as much as 300 feet (90 m) to come to a stop after the
throttle is released. This distance is approximate and is
supplied only for reference. Use good judgement and
always allow plenty of room for stopping.
After releasing the throttle, coast toward the desired
stopping area with the engine idling. You may need to
use the throttle again for steering control.
NOTE: Push the engine stop button before entering
shallow water to prevent sand and debris from entering
the pump and cooling system.
WARNING
Colliding with an object in the water can result in
serious injury to the operator or passengers. All
riders must keep feet, arms and hands inside the
watercraft at all times, and especially while
approaching a dock, vessel or other object. Do not
turn off the engine while approaching an object.
Engine power is required for steering.
300 ft. (90m)
To Next Page
Loading...
Need help?
General