Polaris 2015 800 PRO RMK User Manual

105
MAINTENANCE
Track Maintenance
Track Tension
5. Check for specified slack between the wear surface of the track clip
and the plastic slider. Refer to the Track Tension Data Chart on page
104.
If the track needs adjustment:
6. Loosen the rear idler shaft bolt.
7. Loosen the locknuts.
8. Tighten or loosen the track adjusting screws to provide equal
adjustment on both sides of the track.
9. Repeat the measurement on the other side of the track.
TIP:Check more frequently when the snowmobile is new.
10. Start the engine and slowly rotate the track at least five revolutions.
Let the track come to a stop (do not apply brakes).
11. Check track alignment (see page 106) and adjust as necessary.
12. Tighten the locknuts.
13. Tighten the idler shaft bolts.
14. Torque idler shaft bolts to 35 ft. lbs. (47.5 Nm).
Slack Measurement
Lock Nut
Adjusting Screw
Track
10 lbs. (4.54 kg)
Shaft
Bolt
16 inches
(40 cm)

Polaris 2015 800 PRO RMK Specifications

General

Engine Type	Liberty
Displacement	795 cc
Bore x Stroke	85 mm x 70 mm
Fuel System	Cleanfire Injection
Cooling	Liquid
Electric Start	Optional
Reverse	PERC
Track Width	15 in
Track Length	155 in
Fuel Capacity	11.5 gal. (43.5 L)
Fuel Delivery	Electronic Fuel Injection
Brake	RMK Hydraulic