29
THE PERFECT FIT
Front Suspension Adjustments
Independent Front Suspension (IFS)
For the best ride, the suspension should be adjusted to use the full travel
of the shocks with occasional light bottoming. To determine if your
machine is using full travel, push the jounce bumper down on the shock
rod until it contacts the body and test ride the machine. The bumper will
move up on the rod in relation to the amount of travel that was used dur-
ing the ride. If the travel is full, the bumper will be seated at the top of
the rod.
Shock Components
The front springs can be changed if spring
preload alone isn't sufficient and further
adjustment is desired to control suspension
stiffness. See your Polaris dealer for more
information.
1. Retainer
2. Shock Rod
3. Jounce Bumper
4. Body
5. Threaded Spring Preload Adjuster Nut
WARNING
Always verify ski alignment before making adjustments to the IFS. See page
102 to check alignment. If the skis are misaligned, see your dealer, as the
camber adjustment may also be affected.
2
3
4
5
1
To Next Page
Loading...
Need help?
General
