BATTERY REMOVAL
1. Remove the right side panel to access the battery. See page 74.
2. Disconnect the black (negative) battery cable first.
3. Disconnect the red (positive) battery cable last.
4. Remove the battery.
BATTERY INSTALLATION
When installing a new battery, make sure it's fully charged prior to its initial use.
Using a new battery that has not been fully charged can damage the battery and
result in a shorter life. It can also hinder vehicle performance. Follow the battery
charging instructions outlined in this owner’s manual before installing the
battery.
1. Ensure that the battery is fully charged.
2. Set the battery in the battery holder.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Verify that cables are properly routed.
6. Re-install the battery cover.
7. Reinstall the side panel.
BATTERY IDENTIFICATION
IMPORTANT
It is important to identify what type of battery is installed in the vehicle. Different
types of batteries require different service procedures. Proper servicing and
upkeep of the battery is very important for maintaining long battery life.
The types of batteries are:
• Lead Acid Conventional
• Dry Shipped Absorbed Glass Mat (AGM)
• Lead Acid Low Maintenance
• AGM Low Maintenance
Refer to the examples below to identify the type of battery in your vehicle.
101
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
