BRAKES
HYDRAULIC BRAKE INSPECTION
Inspect the brake lever reserve before each use of the snowmobile. See page
51.
Brake pads must be replaced when the brake pad material becomes thinner
than the backing plate (approximately 1/16 inch or 1.5 mm). A kit is available for
replacing brake pads. See your dealer.
WARNING
Brake failure during operation can result in serious injury or death. Properly
functioning brakes are vital to your safety. Be sure the brake pads do not drag
on the disc and that brake lever travel is not excessive. Always replace brake
pads when the brake pad material becomes thinner than the backing plate
(approximately 1/16 inch or 1.5 mm).
BRAKE COMPONENTS
q
Brake Caliper
w
Brake Disc
e
Brake Pad Material (replace when thickness is less than 1/16 in. or 1.5 mm)
85
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
