Polaris 700 Fusion - Limited Warranty Details

122
TROUBLESHOOTING
M- 10 Suspension Troubleshooting
Problem Solution (perform only one change at a time)
Rear suspension
bottoms too easily
S Increase FRA position (see page 50).
S Install appropriate optional center retainer on rear track shock
(see page 51).
S Increase front track shock coil spring preload.
S Revalve rear track shock compression damping (see your
dealer).
S Check track tension (see page 107).
Rides too stiff in
rear
S Decrease FRA position (see page 50).
S Install appropriate optional center retainer on rear track shock
(see page 51).
S Decrease front track shock coil spring preload.
S Revalve rear track shock compression damping (see your
dealer).
S Check track tension (see page 107).
Machine darts from
side to side
S Make sure skis are aligned properly.
S Make sure spindles and all steering components turn freely.
S Check for excessive play in steering assembly (see your deal-
er).
S Make sure skags are straight on skis.
S Set static sag (see page 44).
S Install dual skags.
Front end pushes S Check for worn skags
S Check for binding suspension shafts and grease all pivot
points.
S Shorten front limiter strap.
S Install single skags (see your dealer).
Steering is heavy S Check ski alignment.
S Make sure spindles and all steering components turn freely.
S Check skags and skis for damage.
S Decrease IFS preload.