Polaris 800 RMK 2011 User Manual

56
OPERATION
Break-In Period
Engine Break-In
Always follow these recommended break-in procedures for new or
rebuilt engines. The first tank of fuel is considered the break-in period
for the engine.
Premix the first tank of fuel as outlined below. Oil added to the fuel and
oil injection systems will provide the necessary engine lubrication.
Tip: The semi-synthetic oil will seat the rings faster than the VES Gold Plus oil.
See page 104 for the part numbers of POLARIS products.
Never mix brands of oil. Serious chemical reactions can cause injection
system blockage, resulting in serious engine damage. Oils may also be
incompatible and the result could be sludge formation, filter blockage,
and reduced cold weather flow rates. All POLARIS oils are compatible
with each other.
Initial Fuel Premix
Always premix fuel in 5-gallon (19-liter) increments in a separate fuel
container. Never add oil directly to the fuel tank.
Oil Recommendations
First Tank of Fuel: POLARIS Premium 2-Cycle Semi-Synthetic Oil
After Break-in: POLARIS VES Gold Plus Oil
Fuel Semi-Synthetic Oil Ratio
Each 5 gal. (19 l) 16 oz. (473 ml) 40:1

Polaris 800 RMK 2011 Specifications

General

Engine Type	Liberty
Displacement	795 cc
Track Length	155 in
Track Width	15 in
Track Height	2.4 in
Fuel Capacity	11.5 gal
Bore x Stroke	85 mm x 70 mm
Starter	Electric
Drive Clutch	P-85
Driven Clutch	Team LWT
Height	48 in
Front Travel	9 in
Rear Travel	16 in
Ski Type	Gripper
Carburetion	Mikuni