Polaris 800 RMK 2011 User Manual

72
MAINTENANCE
Periodic Maintenance Interval Table
I - Inspect (clean, adjust, tighten, lubricate, replace if necessary)
C - Clean R - Replace L - Lubricate
Bolt Torque Inspection
To maintain proper chassis performance, see your POLARIS dealer for
a bolt torque inspection every 1000 miles (1600 km).
Item See
Page
Frequency
150 mi.
(240 km)
500 mi.
(800 km)
1000 mi.
(1600 km)
2000 mi.
(3200 km)
Pre-
Season
CHASSIS
Ski Toe Alignment -- III
Suspension Mounting
Bolts
-- III II
Bolt Torques See your dealer every 1000 mi. (1600 km) for inspection
Rear Suspension
Fasteners
-- III II
Steering Fasteners -- III IC
Suspension Shock Oil -- R
Cooling Fins and
Shroud
-- IIII
Drive Shaft Bearing 76 LLL I
Skags (Wear Bars) 101 III II
Ski Saddle/Spindle Bolts -- III II
Drive Chain Tension 85 III II
Hood and Side Panel
Fasteners
73 III II
Rear Wheel Idler Bolts 97 III II
Idler Bolt Jam Nut 97 III I I
Camber Alignment -- III
Handlebar Centering -- I
Tether Switch and Strap 54 III II
Track Alignment 98 III II
Track Tension 96 III II
Front Limiter Strap -- II I II
Rail Slide Condition 101 I
Chaincase Oil 75 IRI RI
Item Description
Engine Mounting Bolts Remove drive clutch and resonator for access to all bolts
Chaincase Mounting Bolts Two (2) TORX-head bolts on forward side of chaincase
Four (4) rear chaincase nuts

Polaris 800 RMK 2011 Specifications

General

Engine Type	Liberty
Displacement	795 cc
Track Length	155 in
Track Width	15 in
Track Height	2.4 in
Fuel Capacity	11.5 gal
Bore x Stroke	85 mm x 70 mm
Starter	Electric
Drive Clutch	P-85
Driven Clutch	Team LWT
Height	48 in
Front Travel	9 in
Rear Travel	16 in
Ski Type	Gripper
Carburetion	Mikuni