BRAKES
The front and rear brakes are hydraulic disc type brakes activated by the brake
pedal.
Always check brake pedal travel and the brake fluid reservoir level before each
use of the vehicle. When applied, the brake pedal should feel firm. Any
sponginess would indicate a possible fluid leak or low brake fluid level, which
must be corrected before riding.
If you discover any irregularities in brake system operation, including excessive
pedal travel, contact your dealer for proper diagnosis and repairs.
WARNING
Operating the vehicle with a spongy brake pedal can result in loss of braking,
which could cause an accident resulting in severe injury or death. Never
operate the vehicle with a spongy-feeling brake pedal.
BRAKE INSPECTION
1. Check the brake system for fluid leaks.
2. Check the brake pedal for excessive travel or a spongy feel.
3. Check the brake pads
q
for wear, damage and looseness.
4. Inspect the brake pad wear surface for excessive wear.
5. Change pads when the friction material is worn to 1 mm (.04")
w
.
6. Check the surface condition of the brake discs
e
. Measure the thickness.
Replace a disc if the thickness is less than 4.32 mm (.170”).
7. Check brake system hoses and fittings for cracks, deterioration, abrasion
and leaks. Tighten any loose fittings and replace any worn or damaged parts.
78
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
