30
FEATURES AND CONTROLS
Instrument Cluster
Indicator Lamps
Lamp Indicates Condition
Helmet/Seat Belt The lamp is a reminder to the operator to ensure all riders are
wearing helmets and seat belts before operating. The driver's seat
belt is equipped with a seat belt interlock. Vehicle speed will be limited
to 15 MPH (24 km/h) if the seat belt is not secured.
Vehicle Speed
When standard mode is selected, speed displays in miles per hour.
When metric mode is selected, speed displays in kilometers per hour.
Check Engine This indicator appears if an EFI-related fault occurs. Do not operate
the vehicle if this warning appears. Serious engine damage could
result. Your POLARIS dealer can assist.
EPS Warning (if
equipped)
This indicator illuminates briefly when the key is turned to the ON
position. If the light remains on, the EPS system is inoperative. Your
POLARIS dealer can assist.
Over Temperature This lamp illuminates to indicate an overheated engine. If the
indicator flashes, the overheating condition remains, and the system
will automatically reduce engine power.
Check Battery This warning usually indicates that the vehicle is operating at an RPM
too low to keep the battery charged. It may also occur when the
engine is at idle and high electrical load (lights, cooling fan,
accessories) is applied. Drive at a higher RPM or recharge the battery
to clear the warning.
High Beam This lamp illuminates when the headlamp switch is set to high beam.
Low Fuel This lamp illuminates when fuel level in the fuel tank is low.
Neutral This lamp illuminates when the transmission is in neutral and the
ignition key is in the ON position.
Speed Key (optional
accessory)
Information about the speed key is provided in the accessory kit.
To Next Page
Loading...
Need help?
General
