35
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Accessing Menus and Options
Trip Meter
Use a trip meter to track the distance traveled during a
specific trip or period of time. Reset the meter to zero
before traveling.
1. Press either toggle button to cycle to the desired trip
meter option (T1 or T2).
2. Press and hold either toggle button until the meter
resets to zero.
Trip Time
Use a trip time meter to track the travel time during a
specific trip. Reset the meter to zero before traveling.
1. Press either toggle button to cycle to the trip time
option (TT).
2. Press and hold either toggle button until the meter
resets to zero.
Programmable Service Interval
The service interval counter is programmed to 25 hours at the factory. As hours of engine
operation increase, the counter decreases. The wrench icon will flash for about 10 seconds
when the counter reaches zero (0), and each time the key is turned on thereafter, until the
counter is reset.
When this feature is enabled, it provides a convenient reminder to perform routine
maintenance. Refer to the Periodic Maintenance Chart beginning on page 59 for
recommended service intervals.
Use the following procedure to reset or change the service interval.
1. Press and hold the MODE button to enter the settings
menu.
2. Press either toggle button to cycle to the “Service
Hours” option. Press MODE to select.
3. Press MODE to reset the existing value and exit, or
press either toggle button to change the value. Press
MODE to save and exit to the settings menu.
To Next Page
Loading...
Need help?
General
