40
OPERATION
Driving Procedure
1. Wear a helmet, eye protection, gloves, long-sleeve shirt, long pants and over-the-ankle
boots.
2. Perform the pre-ride inspection. See page 38.
3. Sit in the driver's seat and fasten the seat belt.
4. Always make sure all cab doors are closed and latched when riding in this vehicle.
5. Place the transmission in PARK.
6. Start the engine.
7. Apply the service brakes and shift the transmission into gear.
8. Check your surroundings and determine your path of travel.
9. Keeping both hands on the steering wheel, slowly release the brakes and slowly depress
the throttle with your right foot to begin driving.
10. Drive slowly. Practice maneuvering and using the throttle and brakes on level surfaces.
11. Do not carry a passenger until you have at least two hours of driving experience with this
vehicle.
To Next Page
Loading...
Need help?
General
