82
MAINTENANCE
Tires
Wheel Removal
1. Position the vehicle on a level surface.
2. Place the transmission in PARK. Stop the engine.
3. Loosen the wheel nuts slightly.
4. Elevate the side of the vehicle by placing a suitable stand under the frame.
5. Remove the wheel nuts and washers. Remove the wheel.
Wheel Installation
1. Place the transmission in PARK.
2. Place the wheel in the correct position on the wheel hub. Be sure the valve stem is
toward the outside and rotation arrows on the tire point toward forward rotation.
WARNING! Improperly installed wheels can adversely affect tire wear and vehicle handling, which can
result in serious injury or death. Always ensure that all nuts are torqued to specification. Do not service
axle nuts that have a cotter pin installed. Your POLARIS dealer can assist.
3. Attach the wheel nuts and washers and finger tighten.
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts to specification. See page 81.
Fuses
If the engine stops or will not start, or if you experience other electrical failures, a fuse may
need replacement. Locate and correct any short circuits that may have caused the blown fuse,
then replace the fuse. Raise the driver’s seat to access the fuses. Spare fuses are provided in
the fuse box. The power steering fuse (if equipped) is located on the power steering wiring
harness near the fuse box.
If you suspect that a fuse or relay may not be working properly, please see your POLARIS
dealer.
To Next Page
Loading...
Need help?
General
