1. Place the transmission in PARK.
2. Remove the arrestor retaining bolt and nut.
3. Remove the arrestor from the end of the muffler.
4. Use a non-synthetic brush to clean the arrestor screen. A synthetic brush
may melt if components are warm. If necessary, blow debris from the screen
with compressed air.
5. Inspect the screen for wear and damage. Replace a worn or damaged
screen.
6. Reinstall the arrestor.
7. Torque the bolt to 9-11 ft. lbs. (12-15 Nm).
87
MAINTENANCE
To Next Page
Loading...
