BRAKES
The front and rear brakes are hydraulic disc type brakes activated by the brake
pedal.
WARNING
Do not perform maintenance immediately after the vehicle has been operated,
as the brake system may become very hot. Serious burns could result from
contact with hot brake components. Allow components to cool before
proceeding. Always wear eye protection and gloves.
BRAKE FLUID
Inspect the brake system routinely. Inspect the level of the brake fluid before
each operation.
WARNING
After opening a bottle of brake fluid, always discard any unused portion. Never
store or use a partial bottle. Brake fluid is hygroscopic, meaning it rapidly
absorbs moisture from the air. The moisture causes the boiling temperature of
the brake fluid to drop, which can lead to early brake fade and the possibility of
accident or severe injury.
Change the brake fluid every two years and any time the fluid becomes
contaminated, the fluid level is below the minimum, or if the type and brand of
the fluid in the reservoir are unknown.
1. Position the vehicle on a level surface.
2. Place the transmission in PARK.
3. View the brake fluid level at the reservoir in the driver’s side wheel well.
4. The level should be between the upper (MAX) and lower (MIN) level lines.
5. If the fluid level is lower than the upper level line, add brake fluid to the upper
(MAX) line.
6. Apply the brake forcefully for a few seconds and check for fluid leakage
around the fittings.
89
MAINTENANCE
To Next Page
Loading...
Need help?
General
