54
MAINTENANCE
Oil and Filter Change
7. Place towels under the oil filter.
Using an oil filter wrench, turn
the filter counterclockwise to
remove it.
8. Clean the filter sealing surface
on the crankcase.
9. Lubricate the filter o-ring.
10. Install the new oil filter. After
the filter contacts the engine
surface, turn it 1/2 turn by hand.
11. Remove the oil fill plug. Add
850 ml of the recommended oil
(see page 52).
12. Reinstall the fill plug.
13. Start the engine. Allow it to
idle for two minutes. Stop the
engine.
14. Check for oil leaks.
15. Check the oil level. Add oil as
needed.
16. Discard used oil and filter
properly.
To Next Page
Loading...
Need help?
General
