62
MAINTENANCE
Handlebars
WARNING! Improper adjustment of the handlebars or incorrect torquing of the
adjuster block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control and serious injury or death. Follow the
adjustment procedures exactly, or see your Polaris dealer for service.
The handlebars can be adjusted for rider preference.
1. Remove the handlebar cover.
2. Loosen (do not remove) the four handlebar clamp bolts.
3. Adjust the handlebar to the desired height.
4. Be sure the handlebars do not contact the gas tank or any other part
of the machine when turned fully to the left or right.
5. Tighten the front handlebar clamp bolts first, then tighten the rear
bolts. Torque to 34 Nm.
Tip: A gap of up to 3 mm should remain at the rear bolts.
To Next Page
Loading...
Need help?
General
