3. Fill the fuel tank with fuel.
4. Check all the points listed in the Daily Pre-Ride Inspection. Tightness of the
bolts, nuts and other fasteners should be checked by an authorized dealer or
other qualified service facility.
5. Lubricate at the intervals outlined in the Periodic Maintenance Chart.
TRANSPORTING THE VEHICLE
Follow these procedures when transporting the vehicle.
1. Apply the brakes.
2. Place the transmission in PARK. Stop the engine.
3. Slowly release the brake pedal and make sure the transmission is in PARK
before exiting the vehicle. Engage the park brake.
4. Remove the key to prevent loss during transporting.
5. Secure the fuel cap (if equipped) and seat. Ensure that the seat is attached
correctly and is not loose.
WARNING
Cargo and other loose vehicle parts may fly off while transporting this vehicle.
Secure or remove all cargo, and inspect the unit for loose parts prior to
transport. If transporting the vehicle in a non-enclosed trailer, then the vehicle
must FACE FORWARD, or roof must be removed. Failure to comply may allow
airflow, vibration, or other factors to separate the roof from the vehicle and
cause an accident, resulting in serious personal injury or death.
6. Always tie the frame of the vehicle to the transporting unit securely with
suitable straps or rope. Do not attach tie straps to the front control arm bolt
pockets.
127
MAINTENANCE
To Next Page
Loading...
Need help?
General
