EasyManua.ls Logo

Polaris 2013 RANGER 500 Midsize - User Manual

Polaris 2013 RANGER 500 Midsize
93 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
RANGER
®
500
Midsize
RANGER
CREW® 500
Owner's Manual
for Maintenance and Safety

Table of Contents

Questions and Answers

  • C
    christina53Jul 26, 2025
    What to do if my Polaris Offroad Vehicle engine turns over but fails to start?
    • D
      Diana GarciaJul 27, 2025
      If your Polaris Offroad Vehicle's engine turns over but fails to start, it could be due to several reasons. You might be out of fuel, so refuel. Water may be present in the fuel, so drain the fuel system and refuel. Old or non-recommended fuel can also cause this, so replace it with fresh, recommended fuel. Fouled or defective spark plugs can prevent starting, so inspect the plugs and replace them if necessary. A lack of spark to the spark plug can also be the cause, so inspect the plugs and replace if necessary. Low battery voltage can also cause this issue, so recharge the battery to 12.8 VDC. In more serious cases, water or fuel in the crankcase or mechanical failure could be the reason.
  • J
    Jamie ColeJul 30, 2025
    Why does my Polaris Offroad Vehicle engine stop or lose power?
    • Z
      zacharyfoxJul 30, 2025
      If your Polaris Offroad Vehicle engine stops or loses power, several factors could be responsible. Ensure you have enough fuel by refueling. A kinked or plugged fuel vent line can cause this issue, so inspect and replace it if necessary. Water in the fuel can also lead to power loss; replace the fuel with new fuel. Check for fouled or defective spark plugs, and inspect, clean, or replace them if needed. Low battery voltage can also cause the engine to stop or lose power, so recharge the battery to 12.8 VDC. Other potential causes include incorrect fuel, which should be replaced with fresh, recommended fuel, and a clogged air filter, which should be inspected, cleaned, or replaced. The engine could be overheating, so clean the radiator screen and core, and clean the engine exterior.
  • S
    stephaniedominguezAug 12, 2025
    How to fix an engine that doesn't turn over on my Polaris Offroad Vehicle?
    • K
      kimberlyallenAug 12, 2025
      If your Polaris Offroad Vehicle's engine doesn't turn over, it could be due to a few common issues. Check for low battery voltage and recharge the battery to 12.8 VDC. Also, inspect all battery connections and solenoid connections, and tighten any that are loose. Inspect, clean, and reinstall connectors of the loose electronic control box connections.
  • W
    William BauerAug 16, 2025
    What causes engine backfires in my Polaris Offroad Vehicle?
    • C
      Carol WilsonAug 16, 2025
      Engine backfiring in your Polaris Offroad Vehicle can stem from several issues. A weak spark from the spark plug can cause this, so inspect, clean, and/or replace the spark plugs. Incorrect spark plug gap or heat range can also lead to backfiring, so set the gap to specifications or replace the plugs. Old or non-recommended fuel is another potential cause, so replace it with fresh, recommended fuel. Also, replace with fresh recommended fuel if there is water present in fuel. Loose ignition connections can also cause backfiring, so check all connections and tighten them.
  • C
    Christopher PughAug 21, 2025
    Why is my Polaris Offroad Vehicle engine pinging or knocking?
    • K
      Kimberly MasonAug 21, 2025
      If your Polaris Offroad Vehicle engine pings or knocks, it could be due to a few reasons. Poor quality or low octane fuel is a common cause, so replace it with the recommended fuel. Incorrect spark plug gap or heat range can also cause this, so set the gap to specifications or replace the plugs.
  • E
    emccormickNov 3, 2025
    Why is the drive belt wearing or burning on my Polaris Offroad Vehicle?
    • A
      Ashley CoxNov 3, 2025
      Drive belt wear or burn in your Polaris Offroad Vehicle can occur due to several reasons. One common cause is driving onto a pickup or tall trailer in high range. The solution is to use low range during loading. Starting out going up a steep incline can also cause this problem, so use low range. Driving at low RPM or ground speed (3-7 MPH) can also contribute; drive at a higher speed or use low range more frequently. Insufficient warm-up at low ambient temperatures can also cause this. Warm the engine for at least 5 minutes, and with the transmission in neutral, advance the throttle to about 1/8 throttle in short bursts, 5 to 7 times to make the belt more flexible and prevent burning. Slow/easy clutch engagement can cause this problem, so use the throttle quickly and effectively. Other cau...
  • K
    kimberlycarrNov 7, 2025
    Why does my Polaris Offroad Vehicle engine run irregularly, stall, or misfire?
    • K
      Kyle JonesNov 7, 2025
      If your Polaris Offroad Vehicle engine runs irregularly, stalls, or misfires, there are several potential causes. Start by checking the spark plugs for fouling or defects; inspect, clean, and/or replace them as needed. An incorrect spark plug gap or heat range can also cause these issues, so set the gap to specifications or replace the plugs. Loose ignition connections can also lead to irregular engine performance, so check all connections and tighten them. Water in the fuel can also cause these problems, so replace the fuel with new fuel. Low battery voltage can contribute to these issues, so recharge the battery to 12.8 VDC. A kinked or plugged fuel tank vent line can also cause these symptoms, so inspect and replace it. Finally, incorrect fuel can cause these issues, so replace it with ...

Summary

SAFETY

Safety Labels and Locations

Identifies and explains the purpose of various safety labels placed on the vehicle for protection.

Operator Safety Guidelines

Outlines critical rules for safe vehicle operation, including age restrictions and proper conduct.

OPERATION

MAINTENANCE

Periodic Maintenance Chart

Outlines regular service intervals and tasks for optimal vehicle condition and reliability.

Engine Oil and Filter Service

Instructions for checking, changing engine oil, and replacing the oil filter.

Gearcase and Transmission Maintenance

Covers checks and changes for front, main gearcase, and transmission oil levels and procedures.

Cooling System

Information on checking and maintaining coolant levels and radiator fins.

POLARIS Variable Transmission (PVT) System

Maintenance procedures for the PVT system, including belt replacement and debris removal.

Battery Maintenance and Charging

Procedures for battery maintenance, removal, installation, and charging.

SPECIFICATIONS

TROUBLESHOOTING

Drive Belt Wear;Burn

Addresses common problems related to drive belt wear, burning, and slippage.

WARRANTY

Polaris 2013 RANGER 500 Midsize Specifications

General IconGeneral
BrandPolaris
Model2013 RANGER 500 Midsize
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals