What to do if my Polaris Offroad Vehicle engine doesn't turn over?
If your Polaris Offroad Vehicle engine doesn't turn over, it could be due to: * Low battery voltage. * Loose battery connections. * Loose solenoid connections. * Loose electronic control box connections. Recharge the battery to 12.8 VDC, and check and tighten all battery and solenoid connections. Also, inspect, clean, and reinstall the electronic control box connectors.
What to do if my Polaris Offroad Vehicle engine turns over but fails to start?
If your Polaris Offroad Vehicle engine turns over but fails to start, it might be due to: * Being out of fuel. * Water in the fuel. * Old or non-recommended fuel. * Fouled or defective spark plugs. * No spark to spark plug. * Low battery voltage. Refuel, drain the fuel system and refuel with fresh, recommended fuel. Inspect the spark plugs and replace if necessary. Recharge the battery to 12.8 VDC.
Why does my Polaris Offroad Vehicle engine backfire?
Your Polaris Offroad Vehicle engine might backfire due to: * Weak spark from the spark plug. * Incorrect spark plug gap or heat range. * Old or non-recommended fuel. * Water present in fuel. * Loose ignition connections. Inspect, clean, and/or replace the spark plugs, and set the gap to specifications. Replace the fuel with fresh, recommended fuel. Check all ignition connections and tighten them.
Why does my Polaris Offroad Vehicle engine ping or knock?
Your Polaris Offroad Vehicle engine may ping or knock because of: * Poor quality or low octane fuel. * Incorrect spark plug gap or heat range. Replace the fuel with the recommended fuel. Set the spark plug gap to specifications or replace the plugs.
General| Brand | Polaris |
|---|---|
| Model | RANGER 500 EFI 4X4 2012 |
| Category | Offroad Vehicle |
| Language | English |
To Next Page