5. Turn the ignition key past the ON/RUN position to START. Engage the starter
for a maximum of five seconds. Release the key when the engine starts.
6. If the engine does not start within five seconds, return the ignition switch to
the OFF position and wait five seconds. Repeat steps 5 and 6 until the
engine starts.
7. Vary the engine RPM slightly with the throttle to aid in warm up until the
engine idles smoothly.
NOTICE
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
STOPPING THE ENGINE
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in PARK.
3. Turn the key to the OFF position.
4. Slowly release the brake pedal and make sure the transmission is in PARK
before exiting the vehicle.
WARNING
A rolling vehicle can cause serious injury. Always place the transmission in
PARK before stopping the engine.
BRAKING
1. Release the throttle pedal completely.
NOTICE
When the throttle pedal is released completely and engine speed slows to near
idle, the vehicle has no engine braking.
2. Press on the brake pedal evenly and firmly. Practice starting and stopping
(using the brakes) until you're familiar with the controls.
57
OPERATION
To Next Page
Loading...
Need help?
General
