BRAKE SYSTEM BREAK-IN
Apply only moderate braking force for the first 50 stops. Aggressive or overly
forceful braking when the brake system is new could damage brake pads and
rotors.
PVT BREAK-IN (CLUTCHES/BELT)
A proper break-in of the clutches and drive belt will ensure a longer life and
better performance. Break in the clutches and belt by operating at slower
speeds during the break-in period as recommended. Pull only light loads. Avoid
aggressive acceleration and high speed operation during the break-in period.
If a belt fails, always clean any debris from the PVT intake and outlet duct and
from the clutch and engine compartments when replacing the belt.
PRE-RIDE INSPECTION
Failure to inspect and verify that the vehicle is in safe operating condition before
operating increases the risk of an accident. Always inspect the vehicle before
each use to make sure it's in safe operating condition.
ITEM REMARKS PAGE
Brake system/pedal travel Ensure proper operation page 37
page 105
Brake fluid Ensure proper level page 105
Front suspension Inspect, lubricate if necessary page 87
Rear suspension Inspect, lubricate if necessary page 87
Steering Ensure free operation -
Tires Inspect condition and pressure page 109
Wheels/fasteners Inspect, ensure fastener tightness page 109
Frame nuts, bolts, fasteners Inspect, ensure tightness -
Fuel and oil Ensure proper levels page 87
Coolant level Ensure proper level page 96
Coolant hoses Inspect for leaks -
Throttle Ensure proper operation page 38
Indicator lights/switches Ensure proper operation page 33
page 44
Intake pre-filters Inspect, clean -
Headlamps Check operation, apply POLARIS dielectric
grease when lamp is replaced
page 112
50
OPERATION
To Next Page
Loading...
Need help?
General
