4. Check all the points listed in the Daily Pre-Ride Inspection section. Tightness
of the bolts, nuts and other fasteners should be checked by an authorized
POLARIS dealer or other qualified service facility.
5. Lubricate at the intervals outlined in the Periodic Maintenance Chart section.
TRANSPORTING THE VEHICLE
Follow these procedures when transporting the vehicle.
1. Place the transmission in PARK. Stop the engine.
2. Slowly release the brake pedal and make sure the transmission is in PARK
before exiting the vehicle
3. Remove the key to prevent loss during transporting.
4. Secure the fuel cap and seats. Ensure that the seats are attached correctly
and are not loose.
WARNING
Cargo and other loose vehicle parts may fly off while transporting this vehicle.
Secure or remove all cargo, and inspect the unit for loose parts prior to
transport.
If transporting the vehicle in a non-enclosed trailer, then the vehicle must FACE
FORWARD, or roof must be removed.
Failure to comply may allow airflow, vibration, or other factors to separate the
roof from the vehicle and cause an accident, resulting in serious personal
injury or death.
5. Always tie the frame of the POLARIS vehicle to the transporting unit securely
with suitable straps or rope. Do not attach tie straps to the front control arm
bolt pockets.
q
Two Front Tie-Down Points
w
Two Rear Tie-Down Points (or tow
loop)
175
MAINTENANCE
To Next Page
Loading...
Need help?
General
