103
MAINTENANCE
Engine Oil
Oil and Filter Change
10. Place shop towels beneath the oil filter.
Using an oil filter wrench (available
from your POLARIS dealer), turn the
filter counter-clockwise to remove it.
11. Using a clean dry cloth, clean the filter
sealing surface on the crankcase.
12. Lubricate the o-ring on the new filter
with a film of fresh engine oil. Check to
make sure the o-ring is in good
condition.
13. Install the new filter and rotate it
clockwise by hand until the filter gasket
contacts the sealing surface, then turn it
an additional 1/2 turn.
14. Remove the dipstick. Add the proper amount of the recommended
oil. Do not overfill.
15. Reinstall the dipstick.
16. SCRAMBLER: Reinstall the guard plate over the filter access hole.
17. Place the transmission in PARK.
18. Start the engine. Allow it to idle for one to two minutes.
19. Stop the engine.
20. Check for leaks.
21. Check the oil level. Add oil as needed to bring the level to the upper
mark on the dipstick.
22. Dispose of used filter and oil properly.
To Next Page
Loading...
Need help?
General
