37
PRE-RIDE INSPECTIONS
Turn the ignition key to the ON position before performing the electrical pre-ride
inspections. Return the ignition key to the OFF position after completing these inspections.
If inspection of any electrical item reveals component failure, repair or replace the
component before operating the vehicle.
Item Inspection Procedure
See
Page
Electrical
Front Lights Turn the ignition key on. Verify that the headlights, auxiliary lights (if
equipped) and park lamps illuminate. Switch to high beam. Verify that
the high beam indicator comes on and that headlamp brightness
increases. Adjust headlight aim as needed.
74
Rear Lights Verify that the taillights and license plate light illuminate. Apply the
brakes and verify that the taillight lamps increase in brightness.
-
Turn Signals Verify that the left and right turn signals flash at the front and rear of the
vehicle, and that the corresponding indicator lamp flashes in the gauge.
-
Emergency
Flashers
Press the top of the hazard switch to turn the flashers on. Verify that all
four turn signals flash, as well as the lamps in the gauge. Press the
bottom of the switch to turn the flashers off. Verify that all signals and
indicator lamps stop flashing.
-
Horn Press the horn button. Verify that the horn sounds loudly. -
Low Oil Pressure
Indicator
Start the engine and verify that the low oil pressure lamp does not
illuminate.
-
Steering Check power steering for smooth operation. 38
General
Engine Oil Level Check the oil level. 52
Fuel Level View the fuel gauge to check the fuel level. 38
Coolant Level Check the recovery bottle coolant level. 56
Tires Inspect tire condition, pressure and tread depth. 65
Wheels Inspect for loose, damaged or missing wheel nuts. 66
Brake Fluid Level Check the master cylinder brake fluid level. 63
Park Brake Verify that the vehicle does not roll when the park brake is set. 29
Brake System Inspect brake system hoses, connections and brake pads. Check brake
pedal for excessive travel or a spongy feel.
64
Throttle Pedal Check throttle pedal travel, ensure smooth operation and full return. 27
Clutch System Check fluid level and pedal travel. 60-61
Front Suspension Check for suspension wear or damage. 38
Rear Suspension Check for suspension wear or damage. 38
Drive Belt Check for wear or damage. 38,58
Fasteners Inspect entire vehicle for loose, damaged or missing fasteners. 38
Mirrors Adjust for proper side and rear view. -
To Next Page
Loading...
Need help?
General
