62
MAINTENANCE
Brake Fluid
The brake fluid master cylinder reservoir is
located under the hood on the driver’s side of
the vehicle. Check the brake fluid level before
each use of the vehicle. Maintain the fluid level
between the MIN and MAX lines on the
reservoir.
If the BRAKE FAILURE indicator illuminates,
brake fluid may be low. Check the brake fluid
level.
Use DOT 4 brake fluid in the brake fluid
reservoir. Use fluid only from a sealed, clean
container.
Brake Fluid Precautions
Using the wrong fluid or allowing air or contaminants into the fluid system can damage the system
seals or result in a malfunction that could lead to serious injury or death. Use only DOT 4 brake fluid
from a sealed container.
Do not operate the front brake with the reservoir cover removed. Fluid could overflow from the reservoir
and allow air to enter the system. Air in the brake system could cause the brakes to malfunction.
An over-full reservoir may cause brake drag or brake lock-up, which could result in serious injury or
death. Maintain brake fluid at the recommended level. Do not overfill.
After opening a bottle of brake fluid, always discard any unused portion. Never store or use a partial
bottle. Brake fluid is hygroscopic, meaning it rapidly absorbs moisture from the air. The moisture
causes the boiling temperature of the brake fluid to drop, which can lead to early brake fade and the
possibility of accident or severe injury.
NOTICE: Brake fluid will damage painted surfaces and plastic parts. Always clean spilled brake fluid
immediately with water and a mild detergent.
Brake Fluid Change
Change the brake fluid every two years. Always change fluid if the fluid becomes
contaminated, if the fluid condition is questionable, or if the type and brand of the fluid in the
reservoir are unknown. See your authorized dealer for this service.
To Next Page
Loading...
Need help?
General
