FOOTWELL/FOOTWELL SUPPORT REMOVAL (2-UP
MODELS)
To remove the footwell, do the following:
1. Remove the six screws on the bottom of the footwell.
2. Use a flat screwdriver to remove the plastic rivets securing the footwell to the
fenders.
3. Remove the footwell.
4. If removing the footwell support is necessary to access the clutch cover,
remove the hex flange screw securing the support to the frame.
TIRES
WARNING
Operating your ATV with worn tires, improperly inflated tires, non-standard tires
or improperly installed tires will affect vehicle handling and could cause an
accident resulting in serious injury or death. Always follow all tire maintenance
procedures as outlined in this manual and on the labels on the vehicle. Always
use original equipment size and type when replacing tires.
Refer to the specifications section for recommended tire type, size and pressure.
TIRE TREAD DEPTH
Always replace tires when tread depth
is worn to 1/8” (3 mm) or less.
106
MAINTENANCE
To Next Page
Loading...
Need help?
General
